Heat is on in open mode?

Diskussionsarchiv zu den News der Website.

Heat is on in open mode?

Beitragvon johnnyhenderson » So 15. Okt 2017, 10:26

Hi,
I was under the impression the heater and wiper were disabled when using open mode, however, after printing with some Photcentric3D in open mode, I noticed the resin tank seemed warm. So I checked the settings on the machine itself, and the temperature was over 30 degrees C.

Thanks!


I did not find the right solution from the Internet.


References:https://forum.formlabs.com/t/heat-is-on-in-open-mode/11331



promotion animation
johnnyhenderson
Member
 
Beiträge: 79
Registriert: Mo 28. Aug 2017, 14:52

Zurück zu metalingus.de News

Wer ist online?

Mitglieder in diesem Forum: 0 Mitglieder und 0 Gäste

cron